CDDI PROG can program keys to BMW CAS1, CAS2,
CAS3, CAS3+, FEM, BDC. Here, i will display how to use CGDI PROG BMW for F31
FEM remote programming.
Remote: 868
Chassis: F020
BMW
F31 FEM
Voltage
test platform
CGDI
PROG BMW
(this
tool supports key matching and new key programming (when all keys are lost) of BMW CAS1, CAS2, CAS3, CAS3+, FEM, BDC)
The
procedure:
Run
CGDI PROG BMW software after finish all connection
Go
to FEM/BDC key match
The
current FEM BDC needs update the ECU program before performing key matching.
Please ensure that the car battery has enough power. The programming process,
please keep the equipment cable connection
Please
remove the FEM BDC and then use the programmer to read and save data from the
95XXX EEPROM chip on FEM BDC computer board
Read
the original car EEPROM data file
The
95128 EEPROM chip
CGDI
PROG BMW is reading the chip data
Save
data
Use
the programmer to write the calculated new data to the 95XXX EEPROM chip , then
put the FEM BDC back into the car
Write
M95128
Check
the FEM connection
Voltage
test platform is on
Use
the programmer to write the calculated new data to the 95XXX EEPROM chip , then
put the FEM BDC back into the car
The
ECU is being programmed...
Again,
write M95128
Again,
write M95128
Voltage
test platform should be on
The
FEM
Please
remove the FEM BDC and then use the BMW CGDI programmer to write the original car
EEPROM data back to 95XXX EEPROM chip and FEM BDC back into the car
Coding
is successful!!!!
Job’s
done.
